The EVCA210 Electric vehicle charge-point adaptor is a compact, easy-to-use adapter designed to perform all the functions required by the electrical contractor to fully test Mode 3 AC Electric Vehicle Charge-points. Specially designed to comply with UK, European, and other international wiring regulations and standards, the EVCA210 may be used on all single- and three-phase electric vehicle charge points with appropriate connectors. It is designed to test the function and safety of a charging point. The adapters allow you to conduct tests using appropriate single or multifunction test instruments on EV charging points in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722. Charging points should be tested as part of the initial installation and repeated periodically.The Megger EVCA210 test adaptors are designed to simulate the connection of an electrical vehicle to the charging point under test. Connection of the adapter enables the operator to trigger the charging process by selecting the appropriate Proximity Pilot (PP) and Control Pilot (CP) states. Test instruments can be connected using either the front mounted mains socket or the 4 mm connection ports L1, L2, L3, N, PE. Two additional CP signal terminals give the operator the ability to measure the CP signal using an oscilloscope.In addition, the adapters have a manual PE Pre-Test feature that allows the user to test for dangerous voltages present on the PE, prior to any other testing of the charge point. If this test fails, testing must cease as potentially dangerous voltages may be present on the PE and faults must be investigated and rectified before continuing. Model EVCA210-UK Input Voltage Up to 250 V (Single phase system) / up to 430 V (three phase system) Input Frequency 50/60 Hz PE Pre-Test Yes - Push button CP Error "E" simulation Push button PP Simulation NC, 13 A, 20 A, 32 A, 63 A CP States A, B, C, D CP Error "E" Yes PE Error (Earth fault) Yes Measuring Ports L1, L2, L3, N and PE Max. 250/430 V, Cat II 300 V, max. 10 A Mains socket Max. 250 V, Cat II 300 V, max. 10 A,Note: Do not load mains socket simultaneously with measuring ports! CP Signal Test Ports Approx. /-12 V, CAT 0 (under normal condition) Measurement category CAT II 300 V Attitude above sea level. 2000 m max. Dimensions (W x H x L) 225 mm x 145 mm x 62 mm(without connection cable and test cable) Weight Approx: 780g CE directive Low Voltage Directive LVD 2014/35/EU Safety IEC/EN 61010-1:2010 IEC/EN 61010-2:030:2010 Working temperature range 0 to 40°C Storage temperature range -10 to 50°C Reference humidity range 10 to 60% relative humidity w/o condensation Working humidity range 10 to 85% relative humidity w/o condensation PRODUCT DATASHEET
